|
Installation is done in four sections. Your flame graphics will ship pre-cut (not all the way) into those four sections, as well
as trimmed along the bottom edge.
You will need to complete the cut to separate the 4 pieces and install each individually, starting toward the center of the
hood.
Note: We are not responsible for any infractions due to the installation of these graphics.
|
Starting with the flame part that goes toward the center of the hood, carefully/slowly peel the backing paper off.
Align the
bottom edge with the bottom edge of the headlight. The flame can wrap around the edge slightly if desired.
Work from the bottom up and burnish into place
with a squeegee or other similar tool. Leave the masking on until all pieces are applied.
Apply the next three pieces in the same manner as above.
Carefully/Slowly remove masking from all flame pieces. Peel from the bottom of the flame up if possible.
Push vinyl into screw-well with your finger or
a pencil or pen tip.
|
