Visor Graphics Installation Instructions

Logos have a clear masking to aid in installation

Hold clear masking and peel
backing paper away.

Hold clear masking and align graphic
over top of the existing label.

Burnish into place firmly using a fingernail
or vinyl squeegee.

Notice that the visor is flipped down
for easier installation.

After burnished in place start peeling masking off.

Peel clear masking at a 180 degree angle
(flat over itself) to avoid lifing the vinyl.

If the vinyl starts to peel up, re-burnish
and wait 15 minutes and try peeling again.

Shown: Charcoal Metallic
with Silver Print.

Logos can be applied so they are facing upright to you when seated, or upright when viewed from outside. Your choice.
Make sure to decide on which way you want them to face before installation.